43
STP Status:
Enable/Disable the STP on the switch.
STP Version:
Specify the STP operation mode.
•
STP:
Enable the Spanning Tree (STP) operation.
•
RSTP:
Enable the Rapid Spanning Tree (RSTP) operation.
Path Cost:
Specify the path cost method.
•
Long:
Specifies that the default port path costs are within the range 1-200,000,000.
•
Short:
Specifies that the default port path costs are within the range 1-65,535.
BPDU Processing
: Specify the BPDU forward method when the STP is disabled.
•
Filtering:
Filter the BPDU when STP is disabled.
•
Flooding:
Flood the BPDU when STP is disabled.
Max Age:
Specify the time interval in seconds for a switch to wait the configuration messages, without
attempting to redefine its own configuration.
Hello Time:
Specify the STP hello time in second to broadcast its hello message to other bridges by
Designated Ports. Its valid range is from 1 to 10 seconds.
Forward Delay:
Specify the STP forward delay time, which is the amount of time that a port remains in
the Listening and Learning states before it enters the Forwarding state. Its valid range is from 4 to 10
seconds.
Tx Hold Count:
Specify the tx-hold-count used to limit the maximum numbers of packets transmission
per second. The valid range is from 1 to 10.
Priority:
Specify the bridge priority. The valid range is from 0 to 61440, and the value should be the
multiple of 4096. It ensures the probability that the switch is selected as the root bridge, and the lower
value has the higher priority for the switch to be selected as the root bridge of the topology.
Port Setup page
STP Status:
Enable/Disable the STP on the specified port.
Path Cost:
Specify the STP path cost on the specified port.
