Pakon Part#124603-F
February 24, 2004
1
Scanner Specifications
Minimum Host Computer Specifications
•
Pentium IV CPU 1.7GHZ or higher
•
1 40GB hard drive to be used for the operating system, application programs, and storage. If
IDE, it must be configured as
Primary Master
.
•
1 40GB hard drive capable of a sustained transfer rate of 30MB/sec. This is to be a dedicated
drive for the scan data buffer. If IDE, it must either be a
Secondary Master
drive or con-
nected using a serial ATA connection. Drive letter must be N:\ and
it must NOT be format-
ted
. This should be a 7200rpm drive.
See the “Disk Management” chapter for more
information on configuring this drive.
•
Windows 2000, Service Pack 2
•
512MB of RAM
•
A motherboard with an integrated USB 2.0 controller as part of the motherboard chipset. A
dedicated port is recommended. USB 2.0 hubs have not been fully tested for reliability.
•
Microsoft USB 2.0 drivers.
•
SCSI CD-RW drive if both hard drives are IDE. (Plextor 12/10/32S or 40/10/40S recom-
mended, and required for Kodak Picture CD support.) If using a serial ATA hard drive, the
CD-R can be an IDE drive. (Plextor CD-R PX-W48, 52/24/52A, or PlexWriter Premium rec-
ommended, and required for Kodak Picture CD support)
•
1.5GB Pagefile.(Virtual Memory)
Power
•
Auto-switching power supply for 100-240VAC
•
50-60Hz Input voltage frequency
•
Standard 3 conductor IEC 320 male power cable connector
Contents of Box
•
F-235 Film Scanner
•
6ft. USB 2.0 Cable
•
Software and User Manual CD
•
Power Cord
Size
•
17.3”W x 13.6”H x 12.6”D with cover on
Resolutions
There are three supported resolutions.
4Base
1000 x 1500
8Base
1400 x 2100