2
CONTENTS
PAGE
2
Guides and Warnings
3
Nicheless Installation
6
Connecting Light
7
Connecting to driver
8
Troubleshooting
8
Terms and Conditions
GUIDES AND WARNINGS
Tools Required:
Phillips Head No. 2 Screw Driver
IMPORTANT INFORMATION:
DO NOT CONNECT THIS 12V LIGHT DIRECT TO A 120V CIRCUIT.
1) Ensure that the electrical system for your pool conforms with all the requirements of the National
Electrical Code (NEC) and all relevant local codes and ordinances.
2) This 12V Underwater Light must be installed in accordance with the National Electrical Code by
a Certifi ed Electrician or a Qualifi ed Pool Technician. NOTE: No Bonding Terminal is required on
the forming shell since the fi xture is an all plastic construction and complies with NEC article 680
Requirements.
3) This Underwater light is designed for use with the PCR-4 AND PCR-2D UL Listed Class 2 LED Driver.
The Junction Box and the low voltage transformer is located at least 4 (four) inches (10.16 cm) above
ground level or eight (8) inches(20.3 cm) above maximum water level, whichever is higher. The Junction
Box must be at least 48 inches (1.22 m) from the edge of the pool.
To be certain that the pool or spa electrical system meets all applicable requirements, the electrician
should also consult the local building department.
CANADIAN INSTALLATION
Be sure the electrical system of your pool conforms with the following requirements of the Canadian
Electrical Code (CEC), CSA C22.1 and all local codes and ordinances. A licensed or certifi ed electrician
must install the electrical system to meet or exceed those requirements before the light and (fi xture-
housing) is installed. Failure to do so could result in death or serious injury to service technician, pool
users or others due to electrical shock.
