19
51-4771
OPERATION
To adjust gutterbroom swing:
1.
Loosen the nut.
2.
Adjust the capscrew (turn it in for more swing or out for less swing).
3.
Tighten the nut.
When not using the gutterbroom for a short period of time, adjust the tension chain
until the gutterbroom is raised 1” - 2” off the ground. When not using the gutterbroom for
extended periods of time, unhook the hydraulic hoses from the gutterbroom motor, remove the
gutterbroom assembly and connect the hydraulic hoses to run only the main sweeper.
OPTIONAL DUST SUPPRESSION
The dust suppression systems are available for a 12 Volt or 24 Volt system and both
contain a 25 gallon water tank and enough nozzles and hose to use with or without the optional
gutterbrooms.
STORAGE
NOTICE!
Do not store the sweeper with weight on the brush. Weight will deform the
bristles, destroying the sweeping effectiveness. To avoid this problem,
place the sweeper on blocks or use storage stands.
Do not store polypropylene brushes in direct sunlight. The material can
deteriorate and crumble before the bristles are worn out.
Keep polypropylene brush material away from intense heat or flame.
• Clean the unit thoroughly, removing all snow, dirt and grease.
• Inspect for visible signs of wear, breakage or damage. Order any parts required and make
the necessary repairs to avoid delays upon removal from storage.
• Tighten loose nuts, capscrews and hydraulic connections.
• Seal hydraulic system from contaminants and secure all hydraulic hoses off the ground to
help prevent damage.
• Store unit in a dry and protected place. Leaving the unit outside will materially shorten its life.
• Do not store unit with weight on brushes. Place the unit on blocks or use storage stands.
HEIGHT ADJUSTMENT CAPSCREWS
SWING ADJUSTMENT CAPSCREWS
