9
51-3000
INSTALLATION
figure 2
figure 3
Brush Head Assembly
1. After installing the mounting and drive
assemblies, position the brush head assembly
(figure 1) in front of the drive assembly.
2. Fasten the brush head assembly to the drive
assembly using 2, 1/2-13 x 1 1/2 inch carriage
bolts, flat washers, lock washers and nuts.
Be sure to position the hardware as high as
possible in the slots (figure 2).
3. Connect the output drive shaft to the gearbox
shaft and to sprocket on the right-hand side of
the brush head assembly. Tighten universal joint
set screws.
• If the sweeper has a telescoping drive shaft,
it may need to be cut to length. Be sure to
cut the same amount off both halves.
• If the sweeper has a rectangular drive shaft
and it is too long, shorten it by loosening the
set screw on the universal joint mounted to
the drive assembly gearbox and then sliding
the drive shaft in.
4. Units with rectangular drive shaft - Install the
output driveline shield (figure 2).
a. Place a washer and plastic bushing on the
bolt welded to the output driveline shield.
Place a washer and plastic bushing on the
bolt welded to the gearbox output shield
(figure 2).
b. Insert the bolt on the output driveline shield
through the hole drilled in the chain shield.
Insert the bolt on the gearbox output shield
through the slot on the output driveline
shield.
c. Place a washer and lock nut on both bolts;
tighten.
NOTE:
Do not over tighten lock nuts. The shield
must be able to slide back and forth when
the brush head is lowered and raised.
Summary of Contents for Sweepster M24 Series
