27
51-4180
MAINTENANCE
LEVELING
Level your sweeper before each use for efficient sweeping and even brush wear.
1.
Drive the unit to a level, paved area.
2.
Move stands to highest position.
3.
Lower the brush into the sweeping position
with the weight of the brush head on the
spring-chain assembly and the bristles just
touching the ground.
4.
Level the mounting/swing assembly using a
level.
•
If the front of the assembly is high, turn
the leveling screws clockwise to lower
it.
•
If the front of the assembly is low, turn
the leveling screws counterclockwise to
raise it.
See Figure #1 for leveling screw locations.
5.
With the brush head assembly straight ahead,
measure from each end of the brush frame
tubing to the ground. See Figure #2.
6.
If the measurements are not equal, loosen
hardware that attaches the brush head
assembly to the swing assembly and slide the
low side of the brush head assembly up in the
slots on the swing assembly.
7.
Repeat steps 5 and 6 until measurements are
equal. Tighten the hardware.
8.
Swing the brush head assembly to the right.
Measure from each end of the brush frame
tubing to the ground. Then, swing the brush
head assembly to the left. Measure from each
end of the brush frame tubing to the ground.
•
If all 4 measurements are the same,
the brush head assembly is level.
•
If the measurements are not equal,
adjust the mounting assembly upright.
For measurements that resemble
Figure #3, turn the leveling bolts
counterclockwise. For measurements
that resemble Figure #4, turn the
leveling bolts clockwise.
9.
Repeat step 8 until the brush head assembly
is level.
FIGURE #1
FIGURE #2
LEVELING SCREWS
Angled
Angled
Left
Right
High
High
Low
Low
FIGURE #3
Angled
Angled
Left
Right
High
High
Low
Low
FIGURE #4
MEASURE
THIS
DISTANCE
