35
Palax D270 Active
Translation
1-2017
8.3.
Changing oil of multiplier gear
Remove both covers from the rear of the machine. See
8.1 Removing the covers.
The oil plugs are located on top and at the lower edge
of the angular gear. Filling 1 and drainage 2, Fig. 8.4.
Fill up with about 0.3 litres of new oil.
Oil type SAE 90.
Lubricating the machine
See the service schedule. Many of the bearings are
lubed-for-life and do not need to be lubricated. If a
lubed-for-life bearing receives too much lubricant, its
gasket may get damaged.
NOTE ! If the machine is left standing for a longer period
of time, it is important that the bearings always be
provided with clean lubricant.
If the machine is used regularly, lubricate the bearings
once a week.
Oil the moving joints daily.
8.4
1
2
8.4.
Electric motor coupling
The coupling of the electric motor is
protected inside the housing. Fig. 8.5
A.
If the coupling makes an unusual
rattling noise, the coupling rubber
and possibly also the coupling claws
are worn out and need to be replaced
without delay
.
8.5
A
8.5.
Oil change
To ensure flawless operation of the machine, the oil must be changed every 500 operating
hours or at least one year after the start of operations.
The oil tank is drained by opening the bottom plug under the tank.
The filter shall be changed for the first time soon after the start-up, because the largest
impurities come loose from the hydraulic system shortly after the start-up.
