28
translation
7.10 Detent end of valve
There is a small hole in the middle of the end plate
of the detent end of the valve for spraying lubricant
onto the moving parts of the valve. The screw in
the middle of the cover plate must be removed
first. (Fig. 32)
Only use oil that does not congeal in frost.
The easiest way is to use a spray bottle with a
nozzle and pipe.
Insert the spray pipe in the hole and press 2-3
times for about 1-2 seconds at a time.
The oil spreads smoothly on the moving parts of
the detent end.
NOTE! Do not use spray Vaseline because it
congeals in severe frost and the valve will not
operate properly.
32
Fig. 32. Detent end of
valve
7.11 Lubricating the spool shifter, Fig. 33
The spool shifter is equipped with a pin and a
ball joint that require regular maintenance and
lubrication.
1. Lift up the edge of the protective rubber of
the spool shifter.
2. Spray lubricant on both sides of the pin and
down on the ball joint.
3. At the same time, check that the rubber is
intact.
33
Fig. 33. Spool shifter
7.12 Structure of the detent end and the correct order of the parts,
Fig. 34
Keep cover C of the detent end depressed while opening screws B, as the stiff
springs can throw the cover off. This can also make the springs and balls of the
detent fly off.
In connection with assembly of the detent end, apply a small amount of Vaseline to
holes A of the detent. This ensures the balls stay properly in position during
assembly. Make sure that parts D and E line up in the right way, as shown in the
picture.
The small holes at the ends of part E are for drainage of condensed water.
During assembly, make sure that the holes come on the underside.
Summary of Contents for C700 COMBI
Page 38: ...34 translation 10 ELECTRIC DIAGRAMS ...
Page 39: ...35 translation ...
