Palax KS50s
Translation
1-2012
12
2.3 Installing the winch, Figure 2.5
The machine is equipped with a winch for
changing the splitting wedge and manoeuvring the
in-feed conveyor extension.
The winch is delivered separately with the
machine.
Lower the peg at the lower end of the winch
support (1) into the socket (2) in the winch lug.
Fasten the winch support to the socket using the
screw and the washer (3) that were delivered with
the winch.
2.4 Topping up hydraulic oil, Fig. 2.6
The volume of hydraulic oil is 120 litres.
Oil type Univis 32, SHELL Tellus 32, NESTE
HYDRAULI 32 or equivalent.
Only use fresh, clean oil, because smooth
operation of the machine is highly dependent
on the purity of the oil.
Check the oil level regularly by means of the
dipstick 2.
2.5 Checking and topping up the saw-chain oil, Fig. 2.7
The oil tank for the saw-chain is located in the saw
housing at the rear of the machine.
Regularly check the level of the saw-chain oil in the
level hose 1.
Top up the oil, as necessary. The volume of the tank
is about 9 litres.
