Palazzetti EcoFire IDRO Installation Manual Download

Page: 37 / 148

004772533 - 16/03/2021

ENGLISH

to any part that could expose them to danger.
Therefore, they must not be allowed to in-
tervene on internal parts at risk (electrical or
mechanical), even if the disconnection of the
power supply is required.

Respect the instructions and warnings high-
lighted on the sign plates displayed on the
appliance.

The sign plates are accident prevention de-
vices, therefore they must always be perfectly
legible. If these are damaged and unreadable,
it is mandatory to replace them, requesting the
original spare parts from the Manufacturer.

Follow the routine and extraordinary mainte-
nance schedule carefully.

Do not use the appliance without having first

carried out daily cleaning.

Do not use the appliance if operation is ab-
normal, you suspect a breakage or if there are
unusual noises.

In case of failure or malfunction, turn the appli-

ance off and immediately contact your special

ised technician.

Do not throw water on the appliance in opera-

tion or to extinguish the fire in the burn pot.
Do not switch the appliance off by disconnect

ing the mains electrical connection.

Do not lean on open doors, this could compro-
mise the stability of the appliance.

Do not use the appliance as an anchor support
of any kind.

It is prohibited to use the product as a ladder or
support structure.

Do not clean the appliance until the structure
and ashes have completely cooled.

Only touch the door when the appliance is cold.

In case of flue gas leaks in the room or ex

plosions detrimental to the device, turn it off,

ventilate the room and immediately contact
your installer/service technician.

In case of fire in the chimney flue, turn the

appliance off, disconnect it from the power

supply and do not open the door. Then call the

competent authorities.

In case of failure of the ignition system, do not

ignite the appliance with flammable materials.

In electrically powered devices, if unburned

gas/fumes accumulate inside the fire box, do

not disconnect the electrical power supply
and move as far away from the appliance as
possible.

In case of malfunction of the appliance due to

a poor flue draught, clean the flue in accord

ance with the procedure described in section

"Cleaning the flue" on page 59.

Do not touch the painted parts during opera-
tion to avoid damage to the paintwork.

All responsibility for improper use of the prod-
uct is fully borne by the user, who relieves the
manufacturer of any civil and criminal liability.

It is prohibited to operate the appli-
ance with the door open.

It is prohibited to use the appliance if the door
glass or gaskets are damaged.

Any type of unauthorised handling or replace-
ment with non-original spare parts shall place
the safety of the operator at risk and relieve the
manufacturer of any civil and criminal liability.

It is prohibited to manually load pel-
lets into the burn pot; this type of
incorrect behaviour may generate an
abnormal amount of unburned gas,

giving rise to the risk of explosion

inside the chamber.

Unburned pellet deposits in the burn pot after a
failed ignition must be removed before making
a new ignition attempt.

If the burn pot is not cleaned and regularly ser-
viced, malfunctions and explosions may occur
inside the appliance. Be sure to remove all
traces of material and deposits from the holes
of the burn pot and to clean them each time
the ash is emptied or after each failed ignition
attempt. Make sure the burn pot holes don’t
decrease in size as this may have a negative

effect on the safe operation of the appliance.

Do not wash the product with water. Water

may infiltrate the unit and damage the electri