2 Safety warning
2.1 Warnings for the installer
Observe the prescriptions contained in this manual.
The instructions for assembly and disassembly of the
appliance are reserved for specialist technicians only.
It is always recommended that users contact our after
sale service to request qualified technicians. In the case
other technicians are involved, it is recommended to
verify their actual abilities.
The responsibility of the works carried out in the area
where the fireplace will be installed falls, and remains,
on the user; the latter is also entrusted with the execution
of the inspections related to the installation solutions
proposed.
The installer must comply with all local, national and
European safety regulations.
The appliance must be installed on floors with adequate
load bearing capacity.
Verify that the chimney flue and air inlet predispositions
conform to the type of installation.
Do not carry out flying electrical connections with
provisional or not isolated cables.
Check that the earthing of the electrical system is efficient.
Before starting the installation or disassembly of the
fireplace, the installer must comply with the safety
precautions required by law and in particular:
- must not operate in adverse conditions;
- must operate in perfect psychophysical conditions and
must check that the personal protective equipment is
intact and functioning perfectly
- must wear safety gloves and shoes
- must use tools with electrical insulation;
- must make sure that the area involved in the assembly/
dismantling phases is free from obstacles.
26
cod. 004777520 - 21/03/2019 - Palazzetti - PN - Italy
Summary of Contents for ECOMONOBLOCCO WT F Series
Page 103: ......
