004778990 - 11/02/2022
49
ITALIANO
ENGLISH
DEUTSCH
FRANÇAIS
ESPAÑOL
7 INStallatIoN
7.1 general considerations
In the following sections some indications are
provided to be complied with in order to obtain
the maximum performance from the purchased
product.
The following indications are how-
ever subject to compliance with any
possible national, regional and mu-
nicipal laws and regulations in force
in the country where the appliance is
installed.
Before proceeding with installation of the appli-
ance and the execution of the lining, it is neces-
sary to carry out the following checks:
• check the correct operation of the bypass valve.
7.2 assembly diagram
In
Fig. 9
there is an example of an assembly
diagram.
a)
Chimney flue
B)
External air intake
c)
Heat recovery grate
D)
Counter-hood and fireproof load-bearing
structure
e)
Flue gas duct
F)
Fireproof material
g)
Air recirculation grate
H)
Min. 5 mm distance between cladding and
appliance
The lining must be made of fireproof
material.
If the appliance is installed on a fireplace previ-
ously used by other fire boxes, it is necessary to
carry out thorough cleaning to avoid abnormal
functioning and to prevent possible igniting of
any unburned products that may be deposited
on the inner walls of the same.
Any finish made of combustible material must
be adequately insulated or comply with the
minimum distances indicated in the paragraph
"Place of installation" on page 48
The installation requires the installation of a heat
recovery grate as close as possible to the ceiling
(approximately 20 cm) (
c - Fig. 9
).
Incorrect installation can compromise
the safety of the appliance.
A
E
F
C
D
G
B
H
Product images are for illustrative purposes only
Fig. 9
The electrical system, if present, must
be earthed and equipped with an earth
leakage circuit breaker in accordance
with current legislation.
The flue gas evacuation duct must
be equipped with its own earth
connection.
7.3 adaptation interventions
Check how much space is available in the existing
fireplace, if any, and compare it with the dimen-
sions indicated in the paragraph
"DimensionS"
on page 42
.
If an adaptation operation is necessary, by
cutting or modifying the internal walls of the
existing fireplace, be careful not to compromise
its stability.