50
004778990 - 11/02/2022
7.4 Safety plate
Given the appliance's natural tendency of be-
coming unbalanced frontally, it is necessary to
attach the supplied fixing plate (
a
-
Fig. 10
) to
the back of the installation seat using the M5x12
screws, in order to counterbalance the stresses
when the door is opened.
A
Product images are for illustrative purposes only
Fig. 10
If it is not possible to secure the plate to the back
of the installation seat, it will be necessary to
attach it to one of the two side walls (
B
-
Fig. 11
).
B
Product images are for illustrative purposes only
Fig. 11
7.5 Fume evacuation system
The appliance must be connected to a system
for flue gas evacuation suitable to ensure an
adequate dispersion into the atmosphere of the
combustion products,
in compliance with the
standards eN 1856-1-2, eN 1857, eN 1443, eN
13384-1-3, eN 12391-1, UNI 10683
both in terms of
the size and the materials used in its construction.
The fume duct (
a - Fig. 13
) between the firebox
and the chimney must have the same cross-sec-
tion as the fume outlet of the appliance, as shown
on the technical data sheet
"Technical features"
on page 45
.
The components of the fume evacu-
ation system must be suitable for the
specific operating conditions and be
marked.
It is appropriate to provide, under the chimney
inlet, a collection chamber with inspection for
solid materials and any condensate (
Fig. 12
).
Do not use glass wool or insulating ma-
terial with paper support: they could
ignite.
Product images are for illustrative purposes only
Fig. 12
