54
USE AND & MAINTENANCE
11.2 RESETTING ALARMS
After having checked the type of message, the alarm can be reset by pressing the on/off button
for a few
moments.
11.2.1 Special cases (Technical Service Centre only):
Error “
E 1 0 8
”
If the error code is “
E 1 0 8
”, it may be necessary to re-arm the manual reset thermostat (Fig. 11.1-A) by unscrewing
its cap and pressing the reset button.
Reset the alarm by holding down the on/off button for a few seconds
.
You can now start up the stove again.
Error “
E 1 0 4
”
If the error code is “
E 1 0 4
” proceed as follows:
Remove any foreign bodies inside the brazier.
If this is not possible, run the manual mechanical brazier cleaning procedure:
a) Use the arrow keys
to enter the setup menu
and press key
;
b) Enter the password “7” with key
DQGFRQ¿UPZLWKNH\
;
c) Select submenu
[ 3 2 ]
DQGFRQ¿UPZLWKNH\
;
d) Enter password “54”
e) Hold down key
to start the manual loading system.
:KLOHFOHDQLQJLVLQSURJUHVVKROGWKHPLFURVZLWFK)LJ%GRZQIRU¿YHVHFRQGVPDNLQJVXUHWRNHHS
the brazier door closed.
5HRSHQWKHEUD]LHUGRRUDQGFKHFNWKDWWKHIRUHLJQERGLHVKDYHEHHQFOHDUHGRXW
Reset the alarm by holding down the on/off button for a few seconds
.
Wait a few minutes, then start up the stove again.
Only do this when the stove is off and completely cold.
Fig. 11.1
A
B
Summary of Contents for MULTIFIRE BIO 14
