48
004778930 - 06/12/2021
6.3 Place of installation
For the minimum distances that must be re-
spected when positioning the appliance with
respect to flammable materials and objects, refer
to the instructions in
Fig. 9.
X2
Y2
Z
Y1
X1
Product images are for illustrative
purposes only
Fig. 9
model
X1
X2
Y1
Y2
Z
mX 25:9F
1000 300 450 450 750 mm
Floors made of flammable material such as wood,
parquet, linoleum, laminate or floors covered
with carpets must be protected by a fireproof
base under the appliance that also protects the
front during cleaning from any falling burning
residues.
The manufacturer declines all responsibility for
any variations in the characteristics of the mate-
rial constituting the floor under the protection.
Set up an accessible technical space
for any maintenance work.
Remember to respect the minimum distance
from flammable materials (
X
), shown on the
identification plate of the pipes used to make the
chimney.
Prepare the arrival of the electric line near the
appliance for the connection of the power supply
cable (if present).
•
7 InSTAllATIon
7.1 General considerations
In the following sections some indications are
provided to be respected in order to obtain the
maximum performance from the purchased
product.
The following indications are how-
ever subject to compliance with any
possible national, regional and mu-
nicipal laws and regulations in force
in the country where the appliance is
installed.
Before proceeding with installation of the appli-
ance and the execution of the lining, it is neces-
sary to carry out the following checks:
• check the correct operation of the bypass
valve.
7.2 Dry positioning
It is recommended to dry pre-install the ap-
pliance in order to verify the dimensions of the
various components and air intakes.
It is necessary to align the front part of the ap-
pliance with the internal edge of the marble top,
leaving a gap of 5 mm to allow free expansion of
the appliance (
Fig. 10
).
min. 10 mm
min. 5 mm
max. 5 mm
Product images are for illustrative
purposes only
Fig. 10
