64
004779194 - 14/03/2023
7 INSTALLATION
7.1 General considerations
The following sections provide a number of in-
dications to be complied with in order to obtain
maximum performance from the purchased
product.
The following indications are how-
ever subject to compliance with any
possible national, regional and mu-
nicipal laws and regulations in force
in the country where the appliance is
installed.
7.2 Installation configurations IDRO V
7.2.1 Generator installation on the floor of a
fireplace
If installed on an existing base, pay at-
tention to the hydraulic connections
and condensate drain protruding from
the base of the appliance.
Provide adequate space for the hy-
draulic connections.
In the event of installation in structures with
marble cladding or other materials, the insert
has sliding guides to assist with extracting the
equipment for attaching to the fixing surface
and for carrying out inspections and checks on
the mechanical and electrical components.
Make sure that the base can withstand
the weight of the appliance.
Securely fasten the appliance to the
support base to prevent it from tipping
over when it is pulled out.
• Once the pallet has been removed (refer to par-
agraph: "MOVIMENTAZIONE E TRASPORTO”)
proceed as follows:
• Rest the base on the floor of the chimney (1),
trace and make 4 x Ø8 holes for fixing (2) - use
the base itself as a template - then drill the
holes using a bit with a diameter of 6 mm.
• Insert 8 mm Ø8 anchor plugs in the holes and
secure the base with the screws (3).
Ø8 mm x 4
Ø8 mm x 4
1
1
2
3
Fig. 24
Insert anchor plugs
• Make the flue gas exhaust, combustion air in-
take and hydraulic connections (see chapter
"7.4 Hydraulic system" on page 66).
• Reposition the machine in the sliding guides.
Fig. 25
• Re-assemble the fixing bolts removed previ-
ously.
Fig. 26
• Re-connect the water flow and return flexible
hoses, taking care not to reverse the positions.
• Re-connect the display cable connector, with
its relative mass, to the board and the power
cable.
