A
B
1
2
FIG. 13
8.5 HOW TO USE THE DOOR
To open it, grab the handle and push it up (A) (Fig. 13). Use the protective glove supplied.
While the stove is on, it is necessary to keep the door completely lowered.
Fuel loading operations must be performed with the door fully raised; smoke may escape if it is in an intermediate position.
If the door is not completely closed during operation, the forge effect may occur, resulting in violent combustion and a greater
consumption of wood.
In the event that the door is not working properly, check the lifting mechanisms, reaching them from the inspection panel.
The door sliding and lifting system depends on special bearings that ensure minimum friction and maximum
silence.
Check the proper operation of the bearings annually to keep the system efficient.
When the fire is lit, the door reaches high temperature; use the glove supplied to open it.
The door is equipped
transom type
wing for cleaning the glass (B)
(Fig. 13)
.
When loading wood into the hearth, the door must be opened in two stages:
•
first slowly and partially (3-4 cm), to allow for the smoke valve to open and the smoke in the hearth to be sucked in by the flue
•
then completely, avoiding in this way spillage of the smoke in the environment and allowing the fumes valve to open and
the fumes of the furnace to be sucked from the flue avoiding spillage of the smoke in the environment.
Check on the “product booklet” annexed, any specific characteristics of the model”.
58
Summary of Contents for WT 78F V
Page 151: ...1 2 4 5 6 Fig 18 SPAGNOLO cod 004777090 MBL 19 12 2018 Palazzetti PN Italy 151 ...
Page 153: ......
Page 154: ......
Page 155: ......
