ILP 25/33
Owner’s Manual
Rev.1.4
21
7.4
Decal Placement and Inspection
For operator’s safety, all decals appearing in “Decal Kit” must be placed visibly on the control
side of liftgate to be read by operator. This is typically a combination of decals on the liftgate and
truck/trailer body.
Important: Never remove or paint over any decal. If any decals below require replacement contact
Palfinger Liftgates for replacements.
Decal Kit
Decal
Qty.
Part No.
Description
A
1
ATG-URGWA
Urgent Warning: Elevating gate instructions
B
1
ATG-ILR-ILFS
Operating Instructions
C
1
ATG-BKR
Circuit Breaker Reset (must be located at the
circuit breaker)
D
2
ATG-XXXX
Capacity (check the serial number plate to find out
the gates specific capacity).
E
1
ATG-RESET
Circuit Breaker Protection
F
2
ATG-WLH
Warning: liftgate can crush
G
2
ATG-CTN
Caution: Always stand clear of platform area
H
1
ATG-CAB
Liftgate Shut-Off (Place Decal next to the On-Off
Switch in the Cab)
I
1
ATG-UD
Toggle Switch Decal (At post for trucks. At strut or
trailers).
J
1
ATG-WNG
Warning: Use handle to open (must be located
underneath handle (main section))
It is the installer’s responsibility to determine that the vehicle meets DOT and federal lighting
regulations. Keep in mind that there are different requirements depending on the classification of
the vehicle. This document is not intended to replace published agency regulations, and it is
strongly recommended that the installer references the Code of Federal Regulations (CFR) which
can be viewed at
http://www.ecfr.gov
