Revision 1.0
12
5.
Operation of Liftgate
Before use:
All lift gate functions can be controlled with the 3-button control box, which is mounted on the
curb side of the truck or trailer.
NOTE: Never slide platform in or out with load on the platform.
5.1
Operating the ILSL with Control Box
1. Turn on the liftgate by rotating the ON/OFF-button
on the right hand side of the Control Box
(for different setup of on/off switch check for switch in Cab)
2. Lowering down
By rotating the bottom button clockwise/down
gate will lower out of its storage position
3. Slide out the liftgate
Rotate the top button clockwise/down to slide out the gate
completelly untill it hits the slide stops at the end of the rail.
4. Unfold the platform manually by using the straps.
5. Fold the platform for storage
Lower down the platform to about 3” off the ground.
To fold the platform, flip the tip section onto the main section.
6. Sliding in
Rotate the top button counterclockwise/up to slide
the lift gate underneath the vehicle until the gate
is in its final position and does not slide further back.
7. Raising up
By rotating the bottom button counterclockwise/up
gate will raise up into its storage position.