4 Installation Dimensions
Revision 1.5
- 12 -
Eyebrow
cut out to
clear
platform
4.2.2
Rear sill preparation
To assure that the gate is reaching the body floor, you need to cut out the rear sill of your truck/trailer.
•
If sill is
less than 4“
high
No sill cut out needed
•
If no cut out height is determined in drawing, cut out for best fit.
Keep at least a minimum of 4” of sill
.
•
Reinforce every cut out of the sill to regain sill strength, required by truck/trailer OEM.
46"
12"
12"
70"
Reinforce cut outs
Figure 5 Sill cut-out dimensions - rear view
Figure 6 Sill cut-out – sideview
To avoid interference with the
body, you need to cut out the
back sill.
Height of the cut out is determined in the gate specific drawing
