PTV 33/44/55/66
Owner’s Manual
Rev. 1.0
33
It is the install
er’s responsibility to determine the proper application of the Conspicuity tape, and
to ensure that the vehicle or trailer meets DOT and federal lighting regulations. The following dia-
gram is a guideline for placement on trailers over
80” wide and GVWR of 10,000 Lbs. or more. This
document is not intended to replace published agency regulations, and it is strongly recommend-
ed that the installer refer to the Code of Federal Regulations (CFR) which can be viewed at
H Dimension:
15” < H <60” from ground
to center of tape
Requirement 3:
Red/white reflective tape
applied across the entire
width of the rear under-
ride protection device.
Note:
Not required if no
underride protection is
equipped
Requirement 2:
On each corner: T
wo 12” long white reflective pieces, place ad-
jacently to one another as close to the upper corner of the trailer
as possible
Requirement 1:
Red/white reflective tape
applied across the entire
width of the trailer placed at
an appropriate height H
from the ground
H
Summary of Contents for PTV 35
Page 1: ...PTV OWNER S MANUAL 04 21 ...