22
PALLMANN GmbH l Ein Unternehmen der Uzin Utz AG | Im Kreuz 6 | 97076 Würzburg | T49 931 27964-0 | T49 931 27964-50 I www.pallmann.net
Warning
Tripple-disc plate
► Remove the receptacle plate (with the substrate or
parquet), blow off/suck off with air or clean with a damp
cloth.
► Blow off complete triple disc with air (wear
protective goggles and dust mask), or clean with a
damp cloth.
► Check the coupling for damage and heavy wear.
► Check chain tension and retighten if necessary.
► Check screws to see if screws have come loose.
► Treat chain and sprockets with HSS Dry Lube and
allow to dry briefly.
Attention!
Treat chain and sprockets with HSS Dry Lube from
Würth and allow to dry briefly.
Attention!
In continuous use, we recommend cleaning the triple
disc disc approx. every 2 working hours and treating it
with HSS Dry Lube from Würth.
Weekly maintenance/cleaning for cementitious grin-
ding work
Single disc grinding machine Spider
► daily maintenance and cleaning as described above
► Check suction hose for blockage and clean
►
Check brush wear and tear
► Check clearance of gas pressure shock absorber and
guide rod, if necessary have repair carried out by an
authorised service centre.
► Wipe off coarse dirt on gears, chain tensioner, chain
and base plate with a damp cloth.
► If used on wood, spray thinly with HSS Dry Lube after
wards.
► When used on cementitious substrates, spray thinly
with HSS Dry Lube von Würth.
Attention!
Never use HSS Dry Lube von Würth on wooden floors,
Warning
as the subsequent painting will be faulty.
Attention!
Never leave the machine on a grinding disc or
three disc! Remove appropriate plates or
Place machine on wheels and support rubber.
Attention!
For stairways, always remove weights from the
machine to avoid damaging the gas shock absorber.
7.3 Spare parts
Spare parts can be found on the internet at:
http://webkatalog.wolff-tools.com
8.0 Trouble shooting
Functioning of the electronic speed control:
By turning the control, the target speed can be set from
50 to 400 rpm. When under extreme load, e.g. when using
abrasive gauze on cork with additional weight, the machi-
ne reduces its speed automatically.
The machine switches off automatically in the event of
overloading.
The LED (18) flashes in varying intervals.
... Overload:
The machine has been extremely overloaded.
The machine can be restarted after some seconds.
...Motor overheated:
The machine can be restarted when the LED stops
flashing. This indicates that the motor has cooled and the
machine is operational
...Electronics
overheated:
The machine can be restarted when the LED stops flas
-
hing. This indicates that the electronics have cooled and
the machine is operational.
To remove load from the machine, detach the additional
weight and/or reduce the speed.
Warning
Warning
Warning
