23
PALLMANN GmbH l Ein Unternehmen der Uzin Utz AG | Im Kreuz 6 | 97076 Würzburg | T49 931 27964-0 | T49 931 27964-50 I www.pallmann.net
Trouble Eventual cause
Elimination
9.0 Disposal information
Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling. Only for
EC countries:
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an environmen-
tally correct manner.
Subject to change without notice.
10.0 Guarantee
The warranty period for new Pallmann machines shall last
for one year from the point at which the machine is trans-
ferred / delivered to the customer, insofar as statutory legal
Machine does
run smoothly
Wrong speed not
frequency
Machine does
not start
Power supply
Diconnected
blown fuse
defective cable
or plug
Machine does
not start
Machine over-
loaded
Maschine
läuft nicht an
Machine over-
loaded
Speed frequency
must select in cor-
respondending with
the floor, the tools
an the abraisives.
Have machine
repaired by a
qualified electrici
-
an, resp. change
parts
Take off additional
weight
Tilt the machine
over the transpor-
tation wheels. The
plate is unloaded.
Start the machine
and lower it slowly
on the floor
requirements do not stipulate otherwise.
When validating warranty claims, the invoice or proof of
purchase must always be submitted. All repairs within the
framework of the warranty agreement must be undertaken
by a service Centre that has been accredited by us.
Customers performing their own repairs and/or improper
repairs regularly lead to the exclusion of warranty claims.
The same also applies to incorrect operation and/or use.
Replacement of parts, accessories and other modifica
-
tions to Wolff machines
Users of Pallmann machines enjoy a high level of safety
and reliability of their machine. In order to maintain this
status quo, your Pallmann tool may not be modified from
the condition in which it is delivered without following the
rules below.
These rules apply to both the replacement of parts and
equipping the machine with accessories as well as other
technical modifications.
All work undertaken to your Pallmann machine must
be
undertaken exclusively by a workshop that
has
suitably trained and experienced personnel at its
disposal, as well as the requisite work equipment.
We recommend using authorised service Centre.
In the event of planned replacement of parts, planned
addition of accessories or other planned technical
modifications, an assessment must always be carried
out by an authorised
service Centre or us, as manu-
facturer, before work is commenced.
It is highly recommend that only safety-approved
Original replacement parts and Original accessories
are used, which have been approved by us, as manu-
facturer. Replacement parts and accessories can be
obtained from your authorised service Centre, which
will also be able to undertake professional installation
on your behalf. Original replacement parts and Original
accessories have been checked for safety and suitabili-
ty especially for Pallmann machines.
We are unable to adequately assess the safety and
suitably of non-Original replacement parts.
In order to preserve operational safety and to prevent
damage in the event of technical modifications, of
whatsoever nature, our technical guidelines
must
always be observed
. We are also always happy to
hear from you should you have any other questions
about your Pallmann machine.
Please note that we cannot accept any liability for
damage, insofar as this is sustained as the result of
incorrect work undertaken or as the result of violation
of the rules stated above.
