Page 6 Gecko Star 2.0 01/2017
5.3 Original parts and accessories
Original parts and accessories have been especially designed for the GECKO STAR 2.0. Failure to use orginial parts and
accessories will impact the saftey and integrity of the sanding machine.
5.4 Safety instructions for before and during operation
Before use, always check all parts of the tool for damage and
wear. Parts which are placed under severe stress, such as the sanding plate, are particularly susceptible
to breaking off and cracks. The damaged parts must be replaced immediately with new ones.
Caution
All parts which are subjected to excessive wear, such as sanding plates,
belts, etc. are not covered by any kind of warranty.
During operation, never set the tool down while the sanding plate is running.
The GECKO STAR 2.0 may only be placed down when it has come to a complete stop.
Caution!
Never sand towards the cord. If you sand over the electrical cord, there is fatal risk of
electrical shock.
5.5
Approved clothing
Caution!
Wear suitable workwear! Do not wear loose clothing while operating or working on the
GECKO STAR 2.0. Loose clothing may be caught by moving parts.
5.6
Noise emissions from the tool
The following emissions values have been measured for the GECKO STAR 2.0 edge sander
in accordance with EN 60745:
Sound pressure level
(Lpa)
Idling 90.9 dB Under load
92.6 dB
Sound power level
(LWA)
Idling 101.9 dB Under load
103.6 dB
Measuring inaccuracy:
+ / -
1.5 dB
The noise generated by using the tool is dependent on various factors. Local conditions, such as
the size of the room and the properties of the floor surface have an impact on noise emissions.
Caution! Wear hearing protection!! The levels of noise generated by this machine are damaging to the operators
hearing. While operating the tool, you must wear hearing protection. Hearing protection is provided in the tool bag
Summary of Contents for GECKO STAR 2.0
Page 19: ...Page 19 Gecko Star 2 0 01 2017...
