Palmako FRF28-3633FSC, Assembly Instructions Manual

Installation manual 

Preparation of components: 

Sort the components based on the 
wall plans (see Technical 
specifications) and place them at 
the four sides of the house in the 
installation sequence. 

ATTENTION:

 Never place the 

components directly on grass or a 
muddy surface because it will be 
very difficult or even impossible to 
clean them up later! 

Foundation 

A good foundation is the most important aspect guaranteeing the duration and safety of your house. 
Only a completely level, rectangular and bearing foundation will ensure problem-free installation of the 
house, its stability and especially the matching of the doors. With a good foundation, your house will 
stand for many years more.  

Prepare the foundation so that its upper edge extends from the ground to a height of at least 5 cm. At 
the same time make sure that there are sufficient air apertures under the house floor for ventilation.  

We recommend the following foundation options: 



Strip or spot foundation 



Foundation from concrete or pavement slabs 



Cast concrete bed 

Prepare the foundation so that the foundation joists are propped up on every side with intervals not 
exceeding 50-60 cm. 

Consult an expert in this field or have the foundation prepared by specialists. 

3 Garden house assembly 

ATTENTION

:  



  You will find included in the house package one spare log (longest wall log). 



  You will find included in the house package one spare board (longest roof or floor board). 



  The house package also includes 2-3 marked hitting blocks (wall profile approximately 20-30 cm 

long). 

All of the details listed above ARE NOT mentioned in the specification list. 



  The drawings have the details marked with three-digit position numbers. The exact positions of 

those details that have the third digit “x” can be found in the specification list. 

www.simplylogcabins.co.uk