32
5.7.2. Lighting
Step 1: Press the lighting button for 3 sec
Step 2: Leave it for 10 sec
Step 3: Press it for 3 sec
Step 4: When you leave it, wait for leds will turn on and off for 2 times
Step 5: Press programming button until leds blink 2 times
5.7.2.1. RGB LED Resetting
Press the programming button on the panel for 5 seconds, then press the programming
button on the back of the remote for 2 seconds.
5.8. Using of Remote Control:
5.8.1. Using of Lights
•
“UP” button: It’s ensures Activate on your lighting system. When you press constantly
“UP” button, the LED lights will up through DIMMING feature.
•
“DOWN” button: It’s ensures Passive on your lighting system. When you press constantly
“DOWN” button, the LED lights will down through DIMMING feature.
•
“MY” button: adjust to favorite light intensity automatically.
5.8.2. Using of motors
•
“UP” button: Opens the panels.
•
“DOWN” button: Closes the panels.
•
“MY” button: It stops the motor from running and ensures that the panels remain where
they are.
5.8.3. Transfer the channel on the current remote control to a different remote control.
Step 1: On the current remote, select which channel you want to transfer,
Step 2: On the current control, keep the “PROG” key pressed (LEDs will be turned on and off.)
Step 3: In the new remote, select which channel you want to choose,
Step 4: On the new remote, press and release the “PROG” button. (LEDs will be turned on and off.)
5.8.4. Favorite lighting programming
Step 1: After reaching the desired light intensity, press “MY” button for 5 sec., (LED lights will
blink.) Thus, favorite light programmed.
5.8.5. Favorite lights resetting
Step 1: While in favorite lighting press “MY” button as 5 sec., the LED’s will blink two times.
Thus, favorite lights will be reset.
Summary of Contents for Skyroof Compact
Page 1: ...1 Installation Manual Skyroof Compact ...
Page 29: ...29 ...
Page 48: ...48 www palmiye eu ...
