Before You Begin
Product Safety Warnings
To avoid personal injury or death for yourself and others and to avoid damage to your Palo Alto
Networks hardware, be sure you understand and prepare for the following warnings before you
install or service the hardware. You will also see warning messages throughout the hardware
reference where potential hazards exist.
All Palo Alto Networks products with laser-based optical interfaces comply with 21 CFR
1040.10 and 1040.11.
The following safety warnings apply to all Palo Alto Networks firewalls and appliances, unless a
specific hardware model is specified.
• When installing or servicing a Palo Alto Networks firewall or appliance hardware component
that has exposed circuits, ensure that you wear an electrostatic discharge (ESD) strap. Before
handling the component, make sure the metal contact on the wrist strap is touching your skin
and that the other end of the strap is connected to earth ground.
French Translation:
Lorsque vous installez ou que vous intervenez sur un composant matériel
de pare-feu ou de dispositif Palo Alto Networks qui présente des circuits exposés, veillez
à porter un bracelet antistatique. Avant de manipuler le composant, vérifiez que le contact
métallique du bracelet antistatique est en contact avec votre peau et que l’autre extrémité du
bracelet est raccordée à la terre.
• Use grounded and shielded Ethernet cables to ensure agency compliance with electromagnetic
compliance (EMC) regulations.
French Translation:
Des câbles Ethernet blindés reliés à la terre doivent être utilisés pour
garantir la conformité de l'organisme aux émissions électromagnétiques (CEM).
• I/O ports are intended for intra-building connections only and not intended for OSP (Outside
Plant) connections or any network connections subject to external voltage surge events.
•
Radio Frequency (RF) Radiation Exposure Warning:
Hazardous Radiation Exposure Warning
—Adjustments or procedures other than those specified may result in hazardous RF radiation
exposure. A minimum distance of 50cm (19.7in) must be maintained between the operating
radio antennas and personnel.
•
Antenna Installation Warning:
To avoid hazardous RF radiation exposure, ensure the device
is switched off when installing or changing antennas. The device must only use Palo Alto
Networks approved antennas and accessories.
•
Cellular Devices
: The USB 2.0 port on the cellular device is used for maintenance only.
•
International Statements and Information Pertaining to Radio Products
•
Information on compliance to RF exposure guidelines:
The Palo Alto Networks ION
1200 series devices are designed to comply with the following national and international
standards on human RF exposure, to ensure compliance with these RF exposure standards,
ION 1200 Hardware Reference
8
©
2022 Palo Alto Networks, Inc.
Summary of Contents for ION 1200 Series
