Service the PA-3200 Series Firewall
Replace a PA-3200 Series Power Supply
PA-3200 Series firewalls have either two AC or two DC power supplies (the second power supply
is for redundancy). If one power supply fails, you can replace it without service interrupon as
described in the following procedures.
•
Replace a PA-3200 Series AC Power Supply
•
Replace a PA-3200 Series DC Power Supply
Replace a PA-3200 Series AC Power Supply
The following procedure describes how to replace an AC power supply.
To avoid injury to yourself or damage to your Palo Alto Networks
®
hardware or the data
that resides on the hardware, read the
.
STEP 1 |
Idenfy the failed power supply by viewing the
System
logs or by viewing the power supply
status LEDs described in
Interpret the PA-3200 Series Status LEDs
STEP 2 |
Remove the Velcro strap that secures the AC power cord to the failed power supply and
disconnect the power cord from the firewall.
STEP 3 |
Grasp the handle on the failed power supply and then simultaneously press the release lever
to the le and pull the power supply outward to remove it.
PA-3200 Series Next-Gen Firewall Hardware Reference
37
©
2021 Palo Alto Networks, Inc.
