44
PA-400 SERIES NEXT-GEN FIREWALL HARDWARE REFERENCE | Connect Power to a PA-400 Series
Firewall
Connect Power to a PA-410 Firewall
The following procedure describes how to connect power to a PA-410 firewall.
To avoid injury to yourself or damage to your Palo Alto Networks
®
hardware or the data that
resides on the hardware, read the
.
Set Up a Connection to the Firewall
based on your desired boot mode prior to powering on
the firewall for the first time.
STEP 1 |
Crimp a 14AWG ground cable to a ring lug (cable and lug not included), place the ring lug over
the screw and star washer, then replace the screw to attach the cable to the firewall. Torque
the screw to 25 in-lbs and then connect the other end of the cable to earth ground.
STEP 2 |
Insert the DC connector from the power adapter into the port on the back of the firewall. Snap
the DC connector cable to the cord retainer.
STEP 3 |
Ensure the power adapter itself is appropriately positioned (see
STEP 4 |
Plug the AC connector from the power adapter into your AC power source. After power is
connected, the firewall powers on as indicated by the green power LED next to the PWR port.
The front PWR LED shows green when a functioning power adapter is connected.
Before powering on the firewall, ensure that you have connected your Ethernet cables in
accordance to the mode you wish to boot the firewall in (standard mode or Zero Touch
Provisioning mode) as specified in
Summary of Contents for PA-400 Series
Page 1: ...PA 400 Series Next Gen Firewall Hardware Reference paloaltonetworks com documentation...
Page 4: ...iv TABLE OF CONTENTS...
Page 14: ...14 PA 400 SERIES NEXT GEN FIREWALL HARDWARE REFERENCE Before You Begin...
Page 40: ...40 PA 400 SERIES NEXT GEN FIREWALL HARDWARE REFERENCE Install the PA 400 Series Firewall...
