Palo Alto Networks
Installing the Hardware •
11
Connecting Cables to the Device
To install the PA-500 in a grounded 19-inch rack:
1.
Screw the rack mounting brackets onto the front of the unit using a Phillips head
screwdriver.
2.
Lift the device and position it in the rack.
3.
Align the mounting holes on the attached rack mounting brackets with holes in the rack
rail. Make sure that rack rail holes are selected so that the PA-500 is level.
4.
Insert mounting screws into the aligned holes. Tighten with a Phillips screwdriver.
Connecting Cables to the Device
Figure 4 shows the PA-500 cable connections. Refer to Table 1 for descriptions of the front
panel interfaces.
Figure 4. Cable Connections for the PA-500
Connecting Power
To power the PA-500:
1.
Attach a power cable to the device (Figure 2) .
2.
Plug the cable into a grounded wall outlet.
Console
Management
Network
Summary of Contents for PA-500
