Install the PA-800 Series Firewall
Install the PA-800 Series Firewall in a Four-Post 19-inch
Equipment Rack
The following procedure describes how to install the PA-800 Series firewall in a four-post
equipment rack. Before you begin, make sure you purchased the back brackets (PAN-PA-1RU-
RACK4) to secure the firewall to the back rack-posts.
STEP 1 |
Aach one rack-mount bracket to each side of the firewall in the front-mount posion using
four #6-32 x 5/16” screws for each bracket and torque to 9 in-lbs.
STEP 2 |
Aach one rack-mount rail to each side of the firewall using two #6-32 x 5/16” screws for
each rail and torque to 9 in-lbs.
STEP 3 |
With help from another person, hold the firewall in the rack and secure the front rack-mount
brackets to the front rack-posts using two screws for each bracket. Use the appropriate
screws (#10-32 x 3/4” or #12-24 x 1/2”) for your rack and torque to 25 in-lbs. Use cage nuts
to secure the screws if the rack has square holes.
PA-800 Series Next-Gen Firewall Hardware Reference
21
©
2021 Palo Alto Networks, Inc.
