800-233-5484
PalosSports.com
#PalosSports
4. Insert Part B into the T-Connector (Part A) by
pressing down on the push pin. *Note: Insert the side
of Part B that has the push pin which is closest to the
end of the tube.
5. Insert the other side of Part B into the end of the
assembled crossbar tube. This end should have 3
holes. The push pin should insert into the last
(third) hole.
6. Repeat step 5 for the other T-Connector and
opposite side of the crossbar.
8. Repeat step 7 for the other post and connector.
9. Raise the posts to a high enough setting to allow
for the full length of the target mat hang freely.
10. Next, insert the posts into the two Powrbases.
7. Insert the assembled T-Connector and crossbar
into the top of the tall or short post. Make sure the
push pin on the T-Connector is popped securely
into the second hole on the post.
T-Connector/Crossbar
A
B
Upright Post
