OPERATION
Tuning in (continued)
Use the SEARCH function if desired channels can not be preset with the ASM or if you would like
to preset channels to specific position numbers one by one.
It is convenient to set the channel numbers to the same position numbers using SEARCH and SKIP
functions.
SEARCH
If ASM can not preset the desired channels, or you want to preset the desired channels one by one with
the preferred channel numbers, please make use of SEARCH.
1. Enter into
PRESET
menu, press the
POS+/-
button to select and
highlight
POS
. Press the
VOL+/-
button to select a
desired position number (from 0-255).
Note: you can also press 0-9 button to select a
one-digit position number.
Press --/--- button and number buttons to select a
two-digit or three-digit position number.
2. Press the
POS+/-
button to select
SEARCH.
Press the
VOL+
button to
search channels from current channel to higher
channel. Press the
VOL-
button to search channels
from current channel to lower channel. When a
channel is located, the searching stops, this channel
is then memorized with the preset position number.
Note: you can also make use of
BAND
selection to quicken the
searching process in your desired band. Press the
POS+/-
button to
select
BAND
, pressing the
VOL+/-
button moves the band to the next
one in the sequence below.
V-L
V-H
UHF
PRESET
4
SKIP
ON
BAND
V-L
FINE
AFT
OFF
SEARCH
ASM
S-RCV
OFF
POS
3.When you want to store another channel at another position, repeat steps 1 & 2 above.
Note: After SEARCH, to exit the
PRESET
menu, press the
RECALL
button, or press
PRESET
button or
MENU
button repeatedly until OSD disappears.
To preset channels (SEARCH)
PRESET
20
SKIP
OFF
BAND
V-H
FINE
AFT
OFF
SEARCH
ASM
S-RCV
OFF
POS
PRESET
4
SKIP
ON
BAND
V-L
FINE
AFT
OFF
SEARCH
ASM
S-RCV
OFF
POS
8
