E-6
- AT ANYTIME DURING PLAYBACK, PRESS THE "STOP" KEY
TO
STOP OPERATION OF THE SET THE DISPLAY SHOW THE TOTAL NUMBER OF TRACKS
(SONG) OF THE DISC. THIS WILL RESET THE CD PLAYER TO THE FIRST TRACK
(IF YOU PRESS PLAY AFTER STOP, THE FIRST TRACK WILL ALWAYS START PLAYING).
- AT ANYTIME DURING PLAYBACK, "PRESS AND RELEASE" THE BACK OR NEXT
KEYS :
OR
TO SKIP BACKWARDS OR FORWARDS BY ONE
TRACK, AS DESIRED.
- AT ANYTIME DURING PLAYBACK, "PRESS AND HOLD" THE
KEYS :
OR
TO FAST-REVERSE (REVIEW) OR FAST-FORWARD
(CUE) THE SPECIFIC TRACK, WHICH IS CURRENTLY PLAYING.
BACK OR NEXT
INSERTION & REMOVAL OF DISCS
- WHEN OPENING THE CD-DOOR, ALWAYS ENSURE THE DISC IS NOT IN MOTION
(NOT SPINNING) WHEN YOU OPEN THE CD-DOOR. ALWAYS PRESS "STOP"
KEY TO STOP THE DISC SPINNING FIRST.
- PLACE A CD INTO THE COMPARTMENT WITH THE LABEL-SIDE (PRINTED SIDE
OF DISC) FACING UPWARDS. PRESS DOWN IN THE CENTER PART OF DISC
UNTIL THE DISC "LOCKS" ONTO THE CENTER SPINDLE.
- WHEN THE CD HAS BEEN PLACED ONTO THE CENTER SPINDLE, GENTLY
LOWER THE CD-DOOR DOWNWARDS UNTIL IT LOCKS SHUT.
- THE CD IS NOW READY TO BE PLAYED.
- TO REMOVE A DISC, FOLLOW THE SAME PROCEDURE AS DESCRIBED ABOVE,
EXCEPT TO REMOVE THE CD INSTEAD OF INSERTING IT INTO THE
COMPARTMENT, BY PLACING ONE FINGER AT THE MIDDLE OF DISC
(CENTER SPINDLE) & THE OTHER AT THE EDGE OF THE DISC & GENTLY
PULLING UPWARDS.
- IMPORTANT : ALWAYS HOLD A CD BY ITS EDGES. AVOID GETTING ANY
FINGER PRINTS, SMUDGES OR DIRT ONTO THE SURFACE OF A DISC.
IN CASE THIS HAPPENS, USE A SPECIAL CD-CLEANING CLOTH OR CLEANING
KIT TO REMOVE THE DIRT OR SMUDGES.
NORMAL CD OPERATION
- TURN THE UNIT ON BY PRESS THE "STANDBY/ ON" KEY.
- INSERT A CD AS DESCRIBED.
- PRESS THE FUNCTION KEY UNTIL DISPLAY SHOW "CD".
- THE CD WILL SPIN MOMENTARILY AND THE FIRST TRACK (SONG) WILL START
PLAYING AUTOMATICALLY. THE DISPLAY WILL INDICATE THE CURRENT
TRACK NO. ("01" IF IT IS THE FIRST TRACK).
- AT ANYTIME DURING PLAYBACK, PRESS THE "PLAY/ PAUSE" KEY
TO
PAUSE OPERATION OF THE UNIT. PRESS THE "PLAY/ PAUSE" KEY AGAIN
TO RESUME OPERATION AT THE SAME TRACK & POSITION.
E-5
ELECTRONIC VOLUME CONTROL
- THIS UNIT USES AN ELECTRONIC VOLUME CONTROL
.
- TO INCREASE OR DECREASE THE LOUDNESS OF UNIT, PRESS
THE VOLUME UP (VOL +) OR VOLUME DOWN (VOL -) KEYS RESPECTIVELY.
- RELEASE THE KEY WHEN VOLUME LEVEL IS AT THE DESIRED LOUDNESS.
- SOMETIMES, ESPECIALLY DURING LISTENING TO THE RADIO, YOU MAY NOTICE
A "CLICK-CLICK-CLICK" (REPEATING) SOUND WHEN YOU ARE INCREASING OR
DECREASING THE VOLUME. THIS IS A NORMAL CONDITION & THE SOUND WILL
DISAPPEAR WHEN YOU RELEASE THE VOLUME KEY (WHEN YOU REACH THE
DESIRED VOLUME LEVEL).
(PUSH BUTTON TYPE)
OPERATION OF RADIO
- PRESS THE "ON/STANDBY" KEY ONCE TO SWITCH ON THE UNIT.
- PRESS THE
KEY REPEATEDLY UNTIL THE DISPLAY SHOWS "FM" AND
THE RADIO FREQUENCY.
- ADJUST THE TELESCOPIC ANTENNA AND POSITION OF THE SET TO OBTAIN
THE BEST RECEPTION.
- USE THE "PLAY/ PAUSE" KEY TO SELECT THE DESIRED MODE (FM MONO/STEREO).
IN SOME CASES, WHERE RECEPTION IS POOR, IT MAY BE ADVISABLE TO SELECT
“MONO” MODE, TO IMPROVE CLARITY OF THE RADIO SIGNAL.
F U N C T I O N
MANUAL FREQUENCY ADJUSTMENT (SCAN MODE)
- PRESS (AND IMMEDIATELY RELEASE) THE
KEY OR
KEY TO “SCAN” (MANUALLY ADJUST) THE RADIO FREQUENCY “UP” OR “DOWN”
BY 1-STEP AT A TIME.
- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY AT EACH
STEP’S POSITION.
- WHEN A DESIRED FREQUENCY OR STATION IS REACHED. IT CAN BE SAVED
INTO ONE OF THE “MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).
N E X T
B A C K
AUTOMATIC FREQUENCY ADJUSTMENT (SEEK MODE)
- PRESS AND HOLD (FOR 2 SECONDS) THE
OR
KEYS
TO “SEEK” (AUTOMATICALLY ADJUST) THE RADIO FREQUENCY “UP” OR “DOWN”
TO THE NEXT AVAILABLE RADIO STATION.
- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY OF THE
NEXT STATION THAT IS FOUND.
- WHEN A DESIRED STATION IS REACHED. IT CAN BE SAVED INTO ONE OF THE
“MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).
N E X T
B A C K
RADIO MEMORY (STATION PRESET MEMORY STORAGE)
- AT ANY TIME, THE CURRENTLY DISPLAYED STATION OR FREQUENCY CAN BE
STORED INTO ONE OF THE MEMORY POSITION.
- PRESS
KEY ONCE.
- PRESS
KEY (ON UNIT) TO SELECT DESIRED MEMORY
POSITION. (THERE ARE 20 MEMORY POSITIONS FOR FM BAND).
- PRESS
KEY ONCE TO SAVE THE SELECTED STATION INTO
THE SELECTED MEMORY POSITION.
- TO RECALL ANY SAVED MEMORY, SIMPLY PRESS
KEY, THE SAVED
RADIO-BAND WILL BE RECALLED.
- TO CLEAR THE MEMORY OF ANY POSITION, SIMPLY SAVE A NEW STATION TO
THE SAME MEMORY POSITION.
PROG/ MEM
MEM +
MEM +
PROG/ MEM
AUTOMATIC SCAN AND STORED (STATION MEMORY AUTO STORE)
- PRESS AND HOLD (FOR 2 SECONDS) THE "PLAY/PAUSE" KEY, THIS UNIT WILL
AUTOMATICALLY SCAN ALL STATIONS AND AUTOMATICALLY STORE THE FIRST
20 STATIONS FOUND INTO THE MEMORY PRESETS.
