OPERATING INSTRUCTION:
POWER ON/OFF SWITCH
Press the Power Switch, the appliance will be in "STANDBY" mode. A red light shows on
the control panel. Press "PR-/+" buttons to turn on the set. The red light goes out, and
a green light, shows on the control panel.
If there is no TV signal on the screen for five minutes, the TV set switches to STANDBY
automatically. The red light is on.
Pressing the Power Switch again disconnects the set’s power. The light goes out.
STANDBY:
In STANDBY the set takes power to run the remote control circuitry, but the main power
is disconnected. The Red light is on.
1. Pressing any of these buttons will bring the set out of STANDBY and turn it on.
(1) Position Selector PR(-/+) on the remote control or the front panel will recall the
previous setting.
(2) RECALL will recall the previous setting before the set was turned off.
(3) Digital Numbers 0 ~ 9 will switch the set to whichever number is pressed.
2. To put the set into STANDBY press the ( ) button on the Remote Control
unit. This only turns it OFF, it will not turn it ON.
CHANNEL SELECTION:
This set is pretuned to Australian channels 2, 7, 9, 10 & 28 on those numbers. If you
wish to change the settings or add more channels, the method is quite straightforward.
2
SOUND II INDICATOR
STEREO INDICATOR
SOUND I INDICATOR
POWER SWITCH
POWER INDICATOR
STAND BY INDICATOR
INFRARED SENSOR
PUSH OPEN
PROGRAM
VOLUME
PP
EXTERNAL SPEAKERS
EX./IN SPEAKER SWITCH
VIDEO OUTPUT
AUDIO INPUT
AUDIO OUTPUT
ANTENNA INPUT
VIDEO INPUT
.
.
.
+
POWER CORD
