Pan Acoustics TWM III, Mounting Instructions

© Pan Acoustics GmbH   

Page 7 of 10      

Manual 

Doc. No

.: 2022_01588 - 16.03.2022

4.2. Assembly

I

J

K

Insert the slot nut (A) into the 

rear slot of the speaker through 

the opening in the cover.

Pre-mount the 2 set screws (B) 

into  the  middle  threads  of  the 

slot  nuts.  Position  the  slot  nut 

at  the  midpoint  of  the  speaker 

and  tighten  the  set  screws  so 

that the slot nut can no longer 

move.

Screw  bracket  (speaker)  (C) 

onto  the  mounted  slot  nut  (A) 

using 2 screws (D).

Improperly selected fastening material for wall or ceiling assembly may cause the speaker to fall 

down. 

Prior to assembly, it is necessary to check the wall or ceiling material to which the speaker is to be 

fastened. Be sure to provide suitable fastening material (dowels and matching screws) for assembly.

CAUTION

Fasten  bracket  (wall)  (E)  using 

two  screw  fi xings  suitable  for 

wall mounting.

Install  the  axle  (F)  with  the 

pre-mounted  screw  connection 

(G+H) into holder (wall) (E).

Connect  the  Axle  (F)  with 

screw  (I)  and  washer  (J)  with 

the  mount  (wall)  (D)  on  top 

and bottom.