23
Drawing
1
3.
FUEL QUALITY.
Your stove
is designed to operate
with wood pellets;
however, it can also work with other biomass fuels (ask
your dealer about this). Many types of pellets are sold on the market, with very different quality levels. For this
reason, it is very important to choose pellets free from dirt, with no excessive level of damp nor additives that
compact sawdust.
The stove output may vary depending on the type of pellets you use.
PANADERO
do not have any control on the quality of the pellets you use. For this reason,
PANADERO
cannot
guarantee the full output of your stove nor the eventual premature aging or eventual damage of the gas outlet.
If you use other biomass fuels, please note that the stove’s operating parameters and, in most cases, the
combustion grate, are not the same as those used for wood pellets. Before burning any fuel other than wood pellets,
consult your dealer on whether the desired type of fuel can be used, as well as the requirements it should meet,
and/or the type of grate necessary.
4.
INSTALLATION.
The below security distances and assembly diagrams are given for information only as an adaptation shall be
made depending on the norms in force regarding gas outlet, power, security minimum distances specific to
geographic areas.
The installation of the stoves must be done in the same way, for this reason, only the P90 model will be
exposed. Air inlets will be missed in all drawings as section 4.11 indicates the minimum security distances to be
respected for their installation.
UNPACKING THE STOVE.
4.1.
Remove the packaging and the protective plastic.
4.2.
Remove the screws
or bolts
that fasten the stove to the pallet
and remove it.
4.3.
If our model has a plastic protection, it must be removed before starting it.
MATERIAL REQUIRED FOR INSALLATION.
4.4.
Mandatory
stainless steel pipe (AISI 316L),
never
use
aluminum, galvanized or iron pipe.
4.5.
In cases of humidity in the atmosphere above 60% is
highly recommended
installing a double-walled pipe of
stainless steel.
4.6.
If the stove is installed in a wooden house, the vertical pipe
MUST
be installed using double-wall insulation
and special attention should be paid to the area where it goes through the wall, isolated sockets are
mandatory.
4.7.
If the stove is mounted in a French style, a protective plate must be used to prevent a backflow of gases.
4.8.
Aluminium belt and silicone of high temperature (300
°
C).
Hopper lid.
Fuel.
