8
www.panamax.com
VT1512-IP
Instruction Manual - English
Sample Response –
<status time=”1234567890”>
<voltage>119.14</voltage>
<voltpeak time=”0”>0.00</voltpeak>
<amperage>0.00</amperage>
<wattage>0.00</wattage>
<pwrva>0.15</pwrva>
<pwrfact>0.00</pwrfact>
<pwrcond>0</pwrcond>
<brkrfault>0</brkrfault>
<lastseqstate>1</lastseqstate>
<seq>0</seq>
<cycprog>0</cycprog>
<coprocop>1</coprocop>
<coproclink>1</coproclink>
<coprocimp>0</coprocimp>
<coproccrcerrs>0</coproccrcerrs>
<crcerrs>2</crcerrs>
<outlet id=”1”>1</outlet>
<outlet id=”2”>1</outlet>
<outlet id=”3”>1</outlet>
<outlet id=”4”>1</outlet>
<outlet id=”5”>1</outlet>
<outlet id=”6”>1</outlet>
<outlet id=”7”>1</outlet>
<outlet id=”8”>1</outlet>
<outlet id=”9”>1</outlet>
<outlet id=”10”>1</outlet>
<outlet id=”11”>1</outlet>
<outlet id=”12”>1</outlet>
<tfilestate len=”0” chk=”4294967295” mtime=”4294967295” busy=”0” lock=”0” url=”” />
</status>
Details –
Element Description
voltage measured RMS line voltage, 1 Vac precision.
voltpeak measured peak voltage, 1 Vac precision. “time” attribute represents time of occurrence.
amperage measured total load current, 0.1 Ampere precision.
wattage measured total power consumption, 1 Watt precision.
pwrva measured volt-ampere consumption, 1 VA precision.
pwrfact measured load power factor, 0.01 precision.
pwrcond power condition: 0 = normal; 1 = fault recovery; 2 = under voltage; 3 = over voltage.
seq power sequence state: 0 = no sequence; 1 = sequencing ON; 2 = sequencing OFF.
cycprog group power cycle operation state: 0 = no cycle in progress; 1 = cycle in progress.
outlet state: 0 = outlet OFF; 1 = outlet ON. “id” attribute’s decimal value represents outlet number.
All other elements are for Nortek Security & Control use only.
Send Settings Query
The
Send Settings
query is used to retrieve the device configuration settings. Response settings elements are enclosed in the <settings> element.
Query –
<sendsettings/>
Sample Response –
<settings time=”1234567890”>
… (see Common Attributes section) …
</settings>
Details –
Element Description
settings device configuration settings. See
Common Attributes
section for details.
