Model CTF878 Startup Guide
57
Chapter 3.
3.1.5.6
Entering Analog Outputs
The Analog Output option enables you to enter information to set up output parameters. To enter the option, scroll to
the Main Board entry on the Program Menu and press
[ENTER]
(see Figure 39 below). Then select from the AnalogOut
options and press [
ENTER
].
Note:
Input/Output Menu options may appear in a different order, depending on where each option card is
installed. Cards are numbered from right to left.
Figure 39: Selecting Analog Output
The screen appears similar to Figure 40 below. To step through each parameter, press the [
] key. See the
Program
Menu Map, Figure 47 on page 66.
Figure 40: Analog Output Window
Transducer
Site Program Meter Logging Service
Pipe
Fluid
Path
Standard Volu
User Functions
Correction Factors
AnalogIns (2)
0
50
100
AnalogOut(0:B)
Transducer
Diagnostics
Save Now
Program
elocity, m/s
IO
Main Board (0)
AnalogOut(0:A)
Span
Data Source
Zero
OK
Cancel
Analog Out
Hold Last
NO UNIT
On Error
0
100
4-20 Out Setup
Off
Summary of Contents for CTF878
