DigitalFlow™ XMT868i Programming Manual
55
Appendix C. Programming the XMT868i Using PanaView™
Option Card Analog Inputs
Complete the following steps to set up the analog inputs of an option card installed in Slot 1 (refer to Figure 57 on
page 75):
1.
Double-click on the desired
Input
(A, B, C or D).
Note:
The setup of
Input A
is used as an example. Identical procedures would be used to set up the remaining
inputs.
2. Enter a
Label
of up to eight characters for Input A and click on [Next Item].
3. Double-click on
Off
to disable Input A and return to step 1, or on
Temp
or
Spec
to designate it as a temperature or
special input.
•
OFF
If OFF was selected to disable input A, the meter returns to the
Input
prompt in step 1. Double-click on another input, or
click on [Exit Page] to move to another menu.
•
TEMP
If TEMP was selected to set up input A as a live temperature input, complete steps 4 and 5 below:
4. Enter a value for the
Base
(low) end of the analog input range and click [Next Item].
5. Enter a value for the
Full Scale
(high) end of the analog input range and click [Next Item].
After responding to the above prompt, the meter returns to step 1. Click on [Exit Page]
to proceed to another menu or
option.
•
SPEC
If SPEC was selected to set up input A as a live special input, complete steps 6 through 9 below:
6. Enter a
Name
for Input A and click [Next Item]
.
7. Enter the
Units
of measurement for Input A and click [Next Item].
8. Enter a temperature value for the
Base
(low) end of the analog input range and click [Next Item].
9. Enter a temperature value for the
Full Scale
(high) end of the analog input range and click [Next Item].
After responding to the above prompt, the meter returns to step 1. Click [Exit Page]
to proceed to another menu or
option.
Summary of Contents for DigitalFlow XMT868i
