Appendix C. Programming the XMT868i Using PanaView™
58
DigitalFlow™ XMT868i Programming Manual
Option Card Totalizer Outputs
This type of output issues one pulse per selected volume of flow. The meter produces a pulse each time the
programmed amount of flow passes through the pipe. Complete the following steps to set up the totalizer outputs of
an option card installed in Slot 1:
1.
Double-click on the desired
Output
(A, B, C or D).
Note:
The set up of
Output A
is used as an example. Identical procedures would be used to set up the other
outputs.
2. Double-click on
Off
to disable Output A and return to step 1, or on
Totalizer
to set up output A as a totalizer output.
For a 1-Channel meter, skip to step 4.
3. Double-click on the desired
Channel
option.See Table 45 on page 57 for a description of the channel options
available at the above prompt.
4. Double-click on the desired
Measurement Name
. (Table 44 on page 53 provides a description of the available
parameters.)
Note:
The measurement units that appear in these prompts are those selected in the
Global-System
menu earlier
in this section.
5. Enter a value between 50
sec and 500,000
sec for
Pulse On Time
(the frequency of the totalizer pulses) and
click on [Next Item].
Note:
A complete pulse consists of equal amounts of
ON
and
OFF
times. Choose a value that is compatible with
the counter to be used.
6. Enter a value for the number of measurement units represented by each pulse, and click [Next Item].
After responding to the above prompt, the meter returns to step 1. Click [Exit Page]
to proceed to another menu or
option.
Summary of Contents for DigitalFlow XMT868i
