1
3
4
5
INSTALL THE DCR LENS RETAINER.
Use projector lens shift
to center the projector lens in its opening. Remove the two front
Phillips assembly screws from the lens/mount assembly and
remove the rear retainer (it comes loosely assembled).
Squeeze the retainer with locking tab disengaged to fit into the
projector lens opening and then relax it so that it nests into the inner
rim of the opening with the prongs level and closest to the ceiling.
Once nested, engage the locking tab to prevent release.
PREPARE THE PROJECTOR.
Adjust the projector roll, tilt
and/or yaw so the projector test pattern lines are square to the
screen edges. Now,
and set the JVC
show a 2.4:1 movie
anamorphic menu setting to
. Adjust the
Anamorphic C
projector zoom and vertical lens shift so the movie pattern is centered
on and fits the height of the screen. Make sure the projector lens is
clean and as dust free as possible.
INSTALL THE STE LENS.
After removing the rear STE lens
cover, install the STE lens/mount assembly over the retainer
prongs; remove the front protective film; rotate the assembly so
that any visible edges of the movie appear the same on the left
and right; then insert and tighten the two assembly screws to secure
(do not over tighten).
ADJUSTMENTS
. Tilt the STE lens in its mount to make any
residual image top curvature the same but opposite that at the
bottom. Make final adjustments to projector zoom and vertical
lens shift to produce the best fit of the image to the screen.
Lock the STE lens tilt by tightening the single Phillips tilt lock screw (do
not over tighten). As desired you may want to adjust the projector pixel
alignment (see JVC projector instruction manual).
DECIDE HOW TO WATCH 16:9 CONTENT
. The “classic”
mode to watch 16:9 content is to set the projector anamorphic
mode to
However,
,
Anamorphic D.
Anamorphic C
Anamorphic Off or Zoom
will better fill the full cinema format
screen with 16:9 content with various tradeoffs worth exploring. Note
that menus are always created in 16:9 so some type of switch from
Anamorphic C will be necessary to show complete menu content.
STE-J1 Installation Steps
Assembly
screws
Tilt lock
screw
Locking Tab
