11.15 Configure the settings relating to audio
[Audio] (SW355, SW352, SF346, SF342, SF336,
SF335, SF332, SW316L, SW316, SP306, SP305,
SP302, NP502, NW502S)
Click the [Audio] tab on the “Image/Audio” page. (
®
The settings relating to audio can be configured on this page.
Note
•
Images and audio will not be synchronized. Therefore, images and audio may not always match.
•
Audio may be interrupted depending on the network environment.
[Audio transmission/reception]
Select the communication mode used for audio data transmission/reception between the camera and the PC
from the following.
•
Off:
Does not receive/transmit audio between the camera and the PC. Therefore, the settings and controls
relating to audio will be invalidated.
•
Mic input:
The PC receives audio data from the camera. Audio can be heard with images on the PC.
Images and audio will not be synchronized.
•
Audio output:
Audio data from the PC will be transmitted to the camera. Audio can be heard from the
speaker connected to the camera.
•
Interactive(Half-duplex):
Both reception and transmission are available. However, audio data cannot
simultaneously be transmitted and received.
•
Interactive(Full-duplex):
Both reception and transmission are simultaneously available.
•
Default:
Off
Note
•
Howling may be generated depending on usage conditions. If howling is generated, prevent sound
generated by the PC from entering the PC microphone.
•
When “Multicast” is selected for “Transmission type” on the [JPEG/H.264] (or [JPEG/MPEG-4]) tab of
the “Image/Audio” page, audio transmission will become unavailable while monitoring H.264 (or
MPEG-4) images. To transmit audio from a PC to the camera, click the [JPEG] button on the “Live”
page.
130
Operating Instructions
11 Configure the settings relating to images and audio [Image/Audio]
