Note
•
When a shorter interval is selected, the delay time will be shorter. When a longer interval is selected,
audio interruption may be diminished even though the delay time will be longer. Select the interval
according to the network environment.
•
Audio may temporarily be interrupted and noise may be heard when multiple users are accessing the
camera concurrently. It may be possible to diminish the interruption or noise by setting a longer interval
for “Audio output interval (PC to Camera)”.
•
Audio may sometimes not be heard depending on the network environment.
[Audio output port (PC to Camera)]
Enter the transmission port number (the port number on the camera used to receive audio data transmitted
from the PC).
•
Available port number:
1024-50000 (Only even numbers are available.)
•
Default:
34004
Note
•
The transmission port number entered for “Audio output port (PC to Camera)” will be used only when
“Unicast port (MANUAL)” is selected for “Transmission type” (
®
When “Off” is selected for “H.264 transmission” (or “MPEG-4 transmission”) (
page 79, page 86) or
when “Unicast port (AUTO)” or “Multicast” is selected for “Transmission type”, it is not necessary to
enter the transmission port number.
[Permission level of audio trans./recep.]
Select an access level for audio transmission/reception from the following.
1. Level 1 only/ 2. Level 2 or higher/ 3. All users
•
Default:
3. All users
Note
•
Refer to page 153 for further information about the access level.
132
Operating Instructions
11 Configure the settings relating to images and audio [Image/Audio]
