13.5 Change the AUX name [Alarm] (SW355, SW352,
SF346, SF342, SF336, SF335, SF332, SW316L,
SW316, SP306, SP305, SP302, NP502, NW502S)
Click the [Alarm] tab on the “Alarm” page. (
®
The names of “AUX”, “Open” and “Close” on the “Live” page can be changed.
AUX title
[AUX (Up to 10 characters)]
Enter the name for “AUX” on the “Live” page.
•
Unavailable characters:
" &
•
Default:
AUX
[Open (Up to 5 characters)]
Enter the name for “Open” of “AUX” on the “Live” page.
•
Unavailable characters:
" &
•
Default:
Open
[Close (Up to 5 characters)]
Enter the name for “Close” of “AUX” on the “Live” page.
•
Unavailable characters:
" &
•
Default:
Close
Note
•
AUX is a camera terminal that allows users to operate (Open/Close) arbitrarily from the “Live” page.
For example, an operator can remotely control lights in a place where the camera is installed by
connecting the terminal to the light controller.
13.6 Configure the VMD settings [VMD area]
Click the [VMD area] tab on the “Alarm” page. (
®
The video motion detection areas can be set on this page.
Up to 4 areas can be set. When motion is detected in the set area, it will be regarded as an alarm.
IMPORTANT
•
The alarm occurrence indication button (
®
page 12) will be displayed when motion is detected by the
VMD function.
•
The alarm occurrence indication button will be displayed when receiving an alarm input of a terminal
alarm or a command alarm.
Operating Instructions
141
13 Configure the alarm settings [Alarm]
