59
Operating peripheral equipment using the remote control
Programming the remote control code
You can operate other manufacturers’ components using this TV’s remote control.
Preparation:
•
Connect the plug of the external component to the well outlet.
•
Make sure the component is turned off.
1
TV
VCR
DVD
DBS
RCVR
CBL
AUX
2
POWER
+
CH
VOL
CH
VOL
OK
1
2
3
4
5
6
7
8
0
9
3
Press and hold
POWER
and
OK
together,
for at
least 5 seconds
.
•
The mode selection buttons flashes, and then
release the
POWER
and
OK
.
Select the type of the component.
•
The selected button light and all others go out.
Enter the 3-digit infrared code (see pages 60-62).
•
Factory default setting : Panasonic
•
Press
POWER
to test the operation.
Notes:
• If the component does not operate with the remote control, repeat the procedure
using another code. (Some brands have multiple codes.)
• If an incorrect code is entered, or if the procedure takes longer than 30 seconds,the
programming will fail.
MENU
PLAY
PROG
EXIT
LIGHT
A -ANTENNA - B
SAP
AS
PECT
M
U
TE
RE
CA
LL
BBE
STOP
PAUSE
REC
CH
VOL
CH
VOL
OK
TV/VIDEO
1
2
3
4
5
6
7
8
0
9
PIP MIN
REW
PIP MAX
FF
FREEZE
TV/VCR
PIP
SPLIT
MOVE
SWAP
SEARCH
OPEN/CLOSE
PIP CH
DVD/VCR CH
POWER
CBL
TV
VCR
DVD
DBS
RCVR
AUX
R-TUNE
After selecting the type of component (step 2, above)
1
2
Press to store the code.
CH
VOL
CH
VOL
OK
Press to select the code.
• The code starts from the current device.
• Press
POWER
button to test the operation.
• Repeat the steps until the component code is found. It
may take many attempts before the correct code is found.
CH
VOL
CH
VOL
OK
To find the code not listed in the index
