Automated callers block
In automated callers block function, the unit
will screen the incoming calls before ringing
for allowed calls or end the calls without
ringing when the call is identified as robocalls,
telemarketing calls or other undesirable
calls.The unit will play the automated callers
block greeting message and prompt the caller
to enter an access code in order for the unit to
identify whether the call is automated callers
or not.
You can set the unit to block or unblock mode.
The default setting is
“
Unblock
”
.
Note:
R
The unit connects the call without
prompting to enter access code in the
following situation:
– the caller's phone number matches an
entry in the phonebook (page 41).
– the caller's name matches an entry in
the allow name list (page 38).
– the caller's phone number is memorized
as the white list (page 38).
R
If the number is stored in the call block list
(page 35), the unit disconnect the call
without playing automated callers block
greeting message.
R
The automated callers block feature is not
available:
– when a landline call (or cellular call) is
being received during a cellular call (or
landline call).
– during power backup operation
(page 28).
R
When the answering system answers a call
from a caller which is not registered in the
phonebook, allow name list or white list, the
following operation will be delayed:
– answering a call
– remote turn on
– toll saver
R
When the unit receives a call from a caller
which is not registered in the phonebook,
allow name list or white list in the following
situation, the unit shifts to standby mode:
– when searching the phonebook, caller
list, redial list, call block list, or allow
name list
– when programming
– when using the answering system
– when paging all handsets or base unit
R
Blocked calls are logged in the caller list.
We recommend you to check the caller list
periodically. If neccessary, register the
entry to the phonebook or allow name list to
connect the call next time.
White list
Once the caller enters the access code, the
caller's phone number is memorized in the
white list as unblocked number. White list
callers are allowed to connect without access
code during their next call. 100 items can be
stored to the white list (22 digits max. each).
Note:
R
When the white list memory is full, the
latest call received will replace the old
number stored in the list.
R
White list will be erased when you change
the access code (page 39).
R
White lists will not be displayed to you.
Setting the automated callers
block
1
M
MENU
N#787
2
MbN
: Select the desired setting.
a
M
SAVE
N
a
M
OFF
N
Storing allow name list
You can allow certain caller to pass through
by storing the caller's name to the allow name
list even if you only know the caller names but
not their numbers.You can store up to 100
names (16 characters max.). If the name
stored in the allow name list matches the
incoming Caller ID, the unit rings. Callers
listed in the allow name list is not required to
enter the access code.
Adding allow name list from the caller
list
n
When a cellular phone is paired:
1
MCN
CID
38
For assistance, please visit http://shop.panasonic.com/support
Automated callers block
