‒ 25 ‒
EN
EN
NOTE:
When the tool is set remotely, the signal
generated from another tool nearby may
be received by accident.
To prevent such cases, set the tool in
another room if possible, or keep a dis-
tance from other tools.
[EYFLF]
Confirm the set status of tightening
time reminder
Press the C button.
The set value of tightening time and the current
tightening time are displayed in sequence.
For example, “50” → “35”
[EYFLF]
Error Display
In the event of a tool or battery pack malfunction, the control panel will display an error message.
Please check the tool or battery pack as described in the following chart before having them ser-
viced.
Display
Likely cause
Corrective action
Setting error
Re-initialize the tool using the
remote control. (See page 24.)
The battery pack is too hot.
Stop work and allow the battery
pack to cool before resuming use
of the tool.
The tool is too hot to operate.
Stop work and allow the tool to
cool before resuming use.
The contacts that connect the
battery pack and tool are dirty.
Remove any dirt.
The battery pack has not been
properly inserted into the tool.
Insert the battery pack firmly into
the tool.
The pins on either the tool or
battery pack have worn down.
Replace the battery pack.
Overload, Motor failure. etc.
Stop using the tool immediately.
Tool circuit malfunction, failure,
etc.
NOTE:
When the tightened bolt is further tightened or loosened, the overload protection function (E5)
may be activated.
