19
Menu Display
Setting menu can be displayed in the video output from the VIDEO OUT (MENU) connector in the rear panel of this unit.
Basic structure of the menu
Menu setting is operated with the MENU switch and the SEL
switch.
Menu is divided into main menu, and submenu and setting
items.
Set data is written and saved into the internal memory of this
unit.
Basic operation of menu display
1
Press the MENU switch (page 13) on the front panel for 3
seconds. Setting menu is displayed in the video output
from the VIDEO OUT (MENU) connector.
There are four setting menus, SYSTEM, GENLOCK,
DOWNCON SETTING and SETUP.
2
To open the submenu, turn the SEL switch aligning the
arrow with SYSTEM, GENLOCK, DOWNCON SETTING
or SET UP and then press the SEL switch.
3
Items to set will flash when the arrow (
>
) is moved to
the item to set by turning the SEL switch, and pressing
the SEL switch. Change the setting of the item by turning
the SEL switch.
To increase the setting value:
Turn the SEL switch clockwise.
To decrease the setting value:
Turn the SEL switch counter-clockwise.
To switch between ON/OFF of the setting value:
Turn the SEL switch clockwise to set ON. Turn the SEL
switch counter-clockwise to set OFF.
4
Press the SEL switch.
Flashing of the setting value will stop, and the setting
value will be set.
5
Repeat steps
3
and
4
to continue to change other
settings on the same page.
6
To return to the SYSTEM, the GENLOCK, the
DOWNCON SETTING or the SETUP screen from the
submenu screen, move the arrow to the menu title by
turning the SEL switch, and press the SEL switch.
7
Press the MENU switch once the setting is completed.
It will exit from the menu setting mode, and return to the
normal operation mode.
<Note>
When the system format of the camera recorder is SD,
1080-23.98PsF, 1080-24PsF or 720-60P, the DOWNCON
SETTING item is not displayed in the menu.
MAIN MENU
SYSTEM
GENLOCK
DOWNCON SETTING
SETUP
MAIN MENU
SYSTEM
GENLOCK
DOWNCON SETTING
SETUP
GENLOCK
GL PHASE
:HD SDI
H PHASE COARSE
:+ 28
H PHASE FINE
:+ 28
GENLOCK
GL PHASE
:HD SDI
H PHASE COARSE
:+ 28
H PHASE FINE
:+ 28
MAIN MENU
SYSTEM
GENLOCK
DOWNCON SETTING
SETUP
AG-BS300P_E(VQT2H41)_E.book 19 ページ ２００９年１０月２３日 金曜日 午後６時８分
