7
Before use
(continued)
Be sure to perform a trial
recording
Before any important recording
application, be sure to first test the
system to confirm that video and
sound are recorded properly.
Checking the correct settings is
especially important when using the
“backlight compensation” and “IR
enabled night recording” functions.
Use with specified application
Use only the specified application
software for recorder and camera
setup and control. This application
software runs on a computer and
allows recorder and camera setup
and control via a network
connection. For information on how
to obtain the application software,
consult the supplier of this product.
In this manual, the application
software is referred to as the
“Toughbook-Arbitrator Front End
Software”.
Finding related information
In this manual, the format “see page
00” is used to indicate pages with
relevant information.
Compatible memory cards
Only P2 cards identified by the P2
logo can be used with the recorder.
Never remove the P2 card
while it is being accessed
In some rare cases, the P2 card slot
may become inoperative. When this
is detected, the recorder
automatically restarts itself.
Before disconnecting the
power cable, make sure that
recorder shutdown was
performed properly
Never disconnect the power cable while
•
In no event will Panasonic be liable for
any damages, including any incidental
or consequential damages, stemming
from a failure to record data or from
lost settings or data.
Any of the following actions can
result in problems:
·
Power supply to the recorder is
interrupted or impaired during
recording, for example by starting
an engine.
·
A P2 card is removed during
recording.
•
This product is licensed under the
MPEG-4 Visual patent portfolio
license for the personal and non-
commercial use of a consumer for
(i) encoding video in compliance
with the MPEG-4 Visual Standard
(“MPEG-4 Video”) and/or (ii)
decoding MPEG-4 Video that was
encoded by a consumer engaged
in a personal and non-commercial
activity and/or was obtained from
a video provider licensed by
MPEG LA to provide MPEG-4
Video. No license is granted or
shall be implied for any other use.
Additional information including
that relating to promotional,
internal and commercial uses and
licensing may be obtained from
MPEG LA, LLC.
See http://www.mpegla.com/
the recorder is operating. In particular, if
the power cable is disconnected during
recording, P2 card managing
information and data setting information
may be lost or damaged. If the P2 card
managing information has been
damaged and files can no longer be
read properly, you should format the P2
card. This must be performed in a
computer where the P2 card driver has
been installed.
